[camo]

got a cincinnati milacron arrow 750 with acromatic 2100 control. no drill cycle tool goes to the spot to drill but does not drill move to the next spot and doesnt drill goes to the next spot untill program is over. ran 600 parts 3 days ago with drilling cycle and everything was fine went to next setup an no drilling.

any help would be great
thank you bob

[coop31]

That seems weird. Can you post the program you are trying to run?

[camo]

ya its weird the program is
:M6T1
G95M8
G83H1X-.85Y-.1825Z-.42R0S3500M3F.002J3K.1
H2X.85Y-.1825
H3X-.85Y-.1825
H4X.85Y-.1825
G0Z.5M9
G28P4
M2

all i did was go from the last program to this one no drilling cycle i dont get it

thank for the help
bob

[coop31]

Sorry Bob, I have no ideas for you. The program looks like it's okay, so I really don't know whats going on. Were you able to get it going?

[mallardfizz]

hello
look at the pendant. what leds are on?
regards
mallardfizz

[Bradan Eudy]

Hey, I am having the exact same problem with my arrow 1000. have you figured out this issue yet?

[mallardfizz]

since the previous post couldnt be bothered to reply i'll repeat the question
WHAT BUTTONS ARE ACTIVE ON THE PENDANT?
If you were to drill a grid of 100 holes and the drill broke half way thru then you wouldnt like to have to change the tool and re-drill all of the holes again -SO DRILL REPEAT feature was added. this moves the tool to the R plane of the first hole cycle start would be required and the tool would move to the next holes r plane again cycle start and the tool moves to next r plane. this is repeated untill you come to the hole were you want to resume drilling. the repeat button is de-activated cycle start is pressed and the cycle will resume as normal. what you describe sounds similar to this so please check what buttons are active on your pendant. also check if there are any messages in bottom left hand corner of crt.

[Bradan Eudy]

I will run this program again and check that. thank you for all advice. It is weird that this started out of nowhere. I know it is something stupid becuase it is the same code I was running. I'm just baffled. I am not a fan of these machines.

[Bradan Eudy]

Got it, the single loop light was on and depressed and it drilled fine, thanks man, you really helped me out of a jam and damn this is one of those times i fell kinda dumb :violin: