[mschmitz88]

Hello I am new to this web site and thought I could use some help. Below is my program. When it gets to the reppetitive cycle it throws an alarm 064 shape program not monotonously. I have run the program without the G71 and it goes through fine. Please help.


N10(PROFILE TOOL)
G50S1500
G0T1010M8
G96S500M3
G0G42X1.400Z.1
/G71P100Q101U.02W.002S200D0250F.004R1
N100G0X.825
G01Z.02F.0015
G03X.984Z-.2R.4125F.004
G03X.825Z-.4R.4125F.004
G01X1.225Z-2.02F.004
G03X1.00Z-2.420R.550F.004
G01X1.125F.004
Z-3.1
N101G0G40X1.4Z.1
X5.Z10.
T1000
M1

[dcoupar]

Hello I am new to this web site and thought I could use some help. Below is my program. When it gets to the reppetitive cycle it throws an alarm 064 shape program not monotonously. I have run the program without the G71 and it goes through fine. Please help.


N10(PROFILE TOOL)
G50S1500
G0T1010M8
G96S500M3
G0G42X1.400Z.1
/G71P100Q101U.02W.002S200D0250F.004R1
N100G0X.825
G01Z.02F.0015
G03X.984Z-.2R.4125F.004 <---- increasing diameter
G03X.825Z-.4R.4125F.004 <---- decreasing diameter (not monotonous)
G01X1.225Z-2.02F.004 <---- increasing diameter
G03X1.00Z-2.420R.550F.004 <---- decreasing diameter
G01X1.125F.004
Z-3.1
N101G0G40X1.4Z.1
X5.Z10.
T1000
M1

You'll need to use a Type II cycle (if your machine is so equipped). Try adding a W0 to N100. Also, you don't need to repeat F.004 in each block.

[mschmitz88]

Will I beable to do this on a yasnac controll also or will it need something different

[fordav11]

see the solution here.....
http://www.cnczone.com/forums/mori_l...ogramming.html