Has anyone used or saw some using Mach with a ITX style computer. One like this:
ITX Motherboard
This particular one has no LPT but others do.
I just remeber reading some where that Mach dosen't like on board video or some thing like that?
Has anyone used or saw some using Mach with a ITX style computer. One like this:
ITX Motherboard
This particular one has no LPT but others do.
I just remeber reading some where that Mach dosen't like on board video or some thing like that?
Dennis
Mach3 is better with onboard video than Mach2 was, but it's still a case of trial and error. Same goes for ITX. (trial and error, that is)
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I'll try it later then, now I need to figure out why my motors are spining only at ~60rpm on this computer that I built.
Dennis