Here is my problem, I open Coreldraw and do a simple shape like an ellipse and then use DXFTools to export it to a .dxf file. I then import it into Sheetcam and setup the tool/operation, etc., make sure the switchoffset is used and run a simulation. I then click the P button to generate the g-code, if Mach3 is selected as the post processor there are no problems identified; if MP1000-THC is the post processor it gives a warning that the feed rate is 0 even though it was entered when I set up the tool/operation for the part. When I load the g-code in Mach the drawing does not show up and the code IS NOT g-code.Anyone have an idea on what I did wrong or didn't do with this?