[garyrules]

visual mill 2012 will not produce arc to arc moves in either G02 or G03 on my Heidenhain 151 controller!!! Does anyone know a way around this issue?

[Cantabrigian]

still no luck?

[chmillman]

I would post this in the official Mecsoft forum. --ch

[Cantabrigian]

so far Mecsoft has been very helpful, but it appears to be more of a Heidenhain thing. I'm not sure how to alter our post. Hoping Rick@Heidenhain can be of some help.

[garyrules]

The issue I am having is that the transition from an inside arc to an outside arc will not work or vise versa, it will run with a G01 in between the arcs with a straight or angled line but wont if they run consecutive

[RMARCH]

The issue I am having is that the transition from an inside arc to an outside arc will not work or vise versa, it will run with a G01 in between the arcs with a straight or angled line but wont if they run consecutive

Put a M97 at the end of the line between arcs

[neilw20]

Maybe another decimal place. The ends of the arcs may not be coincident due to rounding errors you can't see.