I have 2 of these lathes and am getting a little ticked at them.
One of them is in overheat alarm at least 10 times a shift.Changed the filter and rewired the fan to run always but still alarms. Any thoughts out there?
Second machine gets low voltage alarm.I haved checked the incoming power and it is well within the 10 percent of the conections offered.I am at the lowest setting on the machine.Are there any bad things going to happen to my machine if I bump the voltage up at the transformer?If I get overvoltage will it alarm or will it crash and burn?
Still like my Mori,s the best