[nirolf]

Hi,
i've just started working with nx8 and i'm trying to build a post for a Moriseiki nmv5000 dcg 5ax BC table table.I'm having trobels with makeing it to put out the right angles for B and C axis in set_csys command.
Can anybody help me with that ? Maybe somebody has the post allready or just that comand?
Thank you!

[1 Infinite Loop]

Have you checked the Siemens NX ftp site? If the exact post isn't there perhaps one of them would be a good starting point.

[underthetire]

If its the fanuc controlled machine, you should have gotten esprit with the machine with the correct post.

[nirolf]

Have you checked the Siemens NX ftp site? If the exact post isn't there perhaps one of them would be a good starting point.

yes i have tried nx site those ones are not finished. those are missing usualy the most important part of a post like mcs rotations .thank you anyway i'll keep reading.

[nirolf]

If its the fanuc controlled machine, you should have gotten esprit with the machine with the correct post.

yes it's fanuc,bad luck for me

[underthetire]

Can you modify the esprit post the machine came with?

[nirolf]

Can you modify the esprit post the machine came with?

the machine didn't came with it.Bad luck again.
i'm trying now to modifie some how the set_csys command from nx to put out the right angles.no luck until now.

[NCexplorer]

I think you just need VNC ( Virtual NC) definitions. Just use PB to define everything in your post. In my side, I would better using MTD for make sure my post running well.