gizmo_454;
Here is a discussion about machining soft jaws:
http://www.cnczone.com/forums/genera...athe_soft.html
gizmo_454;
Here is a discussion about machining soft jaws:
http://www.cnczone.com/forums/genera...athe_soft.html
An open mind is a virtue...so long as all the common sense has not leaked out.
I am still trying to figure out why this thread is in the mill section.
Threads going off topic (after the primary purpose has been filled) is one of the things that make CNCzone fun and interesting. Threads constantly belaboring the topic after it has been fully covered are frustrating.
An open mind is a virtue...so long as all the common sense has not leaked out.
i posted in here because i couldnt find a haas lathe section... where is it??
Scroll down the page a bit and see a box labelled 'Forum Jump' on the right. Drop the menu and you will see Haas Lathes about thirteen lines below Haas Mills which will be at the top.
An open mind is a virtue...so long as all the common sense has not leaked out.