I was looking for a tool that I could remove a lot of material with that wouldn't have pull out concerns. I spoke to Eric at Tormach and he thought the 17mm insert em might do the trick. I had wanted to try an insert mill so gave it a try.

Here's a video of some cutting/testing I did.

http://youtu.be/Ft4n2rCWSG0

I'm really happy with the results. A pretty safe 50ipm .125" depth at about 98 percent width. I can run at 60ipm all else the same but cut it back to a more conservative speed. I'm really happy with its performance.

David