[aravind]

Hi,
I am trying enable USB to serial to a MAZAK Matrix nexus ,installation of the driver to Windows on the machine is successfull and appears in device manager.But I/O settings and any parameters related to TAP and DPR(COM) is not visible and I can not use the PORT,please tell me is there any parameter I need to change on the NC side ?currently NO com port setting is visible only USB and CARD and HDD option is visible.


Thanks in Advance.
Aravind

[MrMazak]

Attached is the Mazak procedure for USB-serial installation. Please note you CANNOT save via USB-serial using CMT mode. It is load programs only. Kind of useless I think. Just use a USB key. Good luck, I never got it to work.

[aravind]

Hi Mr Mazak,
Thanks for the reply,
I have understood this part where I have to install the drivers In windows.
But my pain is that the COM port and settings (I/o settings,TAP,DPR params) are not showing up

Aravind