Can Aspire export the 3d models you create to be able to open them in MeshCAM or CamBam?
I read through their site, but can't tell if their export comments refer to 2d files or 3d.
Thanks,
Matt
Can Aspire export the 3d models you create to be able to open them in MeshCAM or CamBam?
I read through their site, but can't tell if their export comments refer to 2d files or 3d.
Thanks,
Matt
Yes, you can export them as .stl files. Not sure what advantage you'd have using MeshCAM, as Aspire probably gives you a little more control over the toolpaths. (I do have both, btw.)
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)