hi guys
i am now trying to connect my yaskawa sgda***p drives to the BOB to get some motion via mach 3.
the bob has the following for each axis
24v
dir
pul
gnd
so my question is what goes were?
i have looked at other guys using ac servos and drives and they have done the following.
24v - 24v in on servo
gnd to pulse and dir on servo
pul to *pul on servo
dir to *dir on servo.
the servo drive doen't seem to have a +pulse or - pulse so i assume the *pulse is +pulse and *dir is +dir on servo?
am i right thinkin that they is all the inputs i need to get this drive going?
i have my BOB connected to the pc and when running mach3 nothing happens on the board. no lights nothing so this makes me wonder if the signal is actually getting to the BOB.
cheers guys
Dean