DM4400 snap crackle pop tinkle tinkle
I'm not sure if other DM4400 owners have had this problem but I keep knocking the two piece table back splash off of its mounts. Only this time I really did a number on it.
I had installed a positive stop on the back of the vise and when I went to warm up the mill today the bolts hit the back splash and bent it up real bad.
I might be able to hammer it straight, but I think its junk.
So, I guess I'm going to have to fabricate a new one. But at least I get to make it wider than the original one so the chips fall farther away from the table and ways.
Timothy
Dyna Mechtronics DM4400, Bridgeport Discovery 300, HAAS VF-0E, HAAS VF-2D
BobCad 16, 20, 24 and now V25