Hi everyone,
I have just wired up my chinese proximity sensors to my breakout board per the directions, but it does not seem to trip it. My power supply has 3 outputs, 50V for my drivers, 12V (NPN sensor takes 6-36V), and a 5V which feeds my breakout board.
The inputs will trip and show from the +5V from the power supply (the same +5 that feeds the BB) but will NOT register the +5V from the out on the proximity sensor.
Both -'s are common to ground, and I appear to be hooked up exactly as my diagram shows. Like I said, the 5V from the BB and the 5V leg of the power supply will "trip" it just fine.
http://cnc4pc.com/Tech_Docs/C10R10_USER_MANUAL_V2.pdf page 11
Thanks folks!