Hi
Yesterday I had started the machine for the first time
when i switched on the machine, the display shows E-Stop
after releasing the Emergency stop the message E-Stop allways appears
Only when I disconnect the signal cable (2 wires) for the five axis board, the message "E-Stop" disappears in the display
now I can move the axis X, Y, Z and turn on the coolant but the spindle doesn't turn on.
The display always shows 0 RPM even when I turn the rotary switch and
press the "spindle" button
when I connect the signal cable (2 wires) once again , the message E-Stop in the display appears and nothing works.
i have already tried a different emergency switch, without success