586,265 active members*
3,610 visitors online*
Register for free
Login

Thread: Mach 3 post problem

Results 1 to 3 of 3
  1. 04-08-2012, 10:12 PM #1
    DangerousR6
    DangerousR6 is offline Member
    Join Date
    Jun 2011
    Posts
    10

    Mach 3 post problem

    Just wondering if anyone using mach 3 has run into this problem using Dolphin?

    I imported my DXF, run the contour in the cam, no problem. Did the post using the mach 3 post processor. When i load it into my machine, I get an error message.."Radius from end of arc differs from radius from startline 20".

    I'm thinking it's an issue with the X,Y arc offset but not sure..
    Dangerous Guitar neck plates
    http://www.unofficialwarmoth.com/index.php?topic=12426.0
    Reply With Quote Reply With Quote
  2. 04-09-2012, 12:34 AM #2
    John S.
    John S. is offline Registered
    Join Date
    Dec 2003
    Posts
    259
    In Mach3 go to Config > General Config and check that arc's are set to Incremental and then try that.

    John S.
    Reply With Quote Reply With Quote
  3. 04-09-2012, 03:19 AM #3
    DangerousR6
    DangerousR6 is offline Member
    Join Date
    Jun 2011
    Posts
    10
    Quote Originally Posted by John S. View Post
    In Mach3 go to Config > General Config and check that arc's are set to Incremental and then try that.

    John S.
    Yes, IJ mode is set to incremental...
    Dangerous Guitar neck plates
    http://www.unofficialwarmoth.com/index.php?topic=12426.0
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Mach 3 Problem
    By juniormint in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 07-24-2010, 03:05 AM
  2. Rhinocam1/Mach 3 Post-processing problem
    By prdp141 in forum Rhino 3D
    Replies: 0
    Last Post: 01-14-2010, 02:29 PM
  3. Mach 2 Mach 3 Post Processor
    By IntarisiaQ4 in forum Australia, New Zealand Club House
    Replies: 0
    Last Post: 10-17-2009, 11:50 PM
  4. Anybody had this problem in Mach 3?
    By pointcloud in forum Mach Mill
    Replies: 3
    Last Post: 07-13-2007, 02:09 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules