Is there an update on how to cut 2 sided stock without creating new file or new mops?
The new rhinocam can do this ?
Is there an update on how to cut 2 sided stock without creating new file or new mops?
The new rhinocam can do this ?
It's been easy for a long time. You do have to create a new MCS and a new MOp set. That's not very hard. It is unnecessary to create a new file or turn the part.
--ch
Ah, my bad, my bad.
Does rhinocam can create toolpath for inner hole cutting like this sample?
It's just a drawing idea of what i want to cut.
The real material is not a cylinder/symetrical, but the inner hole.
Thanks
As long as you have the proper end mill, sure, you should be able to create the gcode. Simple pocketing or hole cutting should work.
Hole cutting for the inner most hole then swap tool to something of a key cutting type end mill for the next bigger hole.
Well, i have the proper endmil but i have no luck to create the toolpath for this inner hole job.
Appriciate your guide