Hi,
I'm going to be cutting plastic and wood and have a question for when you do multiple passes each one deeper than the last.
Let's say I am cutting through 1/2" and I am going to do 4 passes at 1/8" depth.
Would you perform one pass at 1/8", then 1/4", 3/8", then finally 1/2". Between passes the Z would go deeper 1/8" all at once.
Or would you begin at 0 and transition Z to 1/8" during the entire first pass, then transition from 1/8 to 1/4 during the second pass, etc. This would be sort of a spiral or would look like a pulled spring.
Is either method better or more commonly used?
Thanks,
Alan