[haastec]

I'm relatively new to working on Haas lathes, but as an electrician am familiar with some similar issues in automation. From what we have here at my plant, our lathes are running GE Fanuc which is the older DOS based PLC. I have had communication issues regarding GE Fanuc and todays Windows based softwares. Another occasional issue is programming. Some programmers like to use "oneshots" when writing their logic. The problem being that if you interrupt the program after the oneshot is fired, it does not fire again unless you cycle the power, or go through the program and manually fire the oneshot. I don't know if this helps.

Since this thread is almost 6 years old, I would venture to say they got it sorted out by now.