586,043 active members*
3,696 visitors online*
Register for free
Login

Thread: Meldas Replacing Spindle Drive

Results 1 to 2 of 2
  1. 04-24-2012, 11:15 AM #1
    Jack2012
    Jack2012 is offline Registered
    Join Date
    Apr 2012
    Posts
    0

    Meldas Replacing Spindle Drive

    Hi
    New on here but an old hand at CNC (40Yrs). Faulty spindle (MDS-B-SPJ2-75) drive on XYZ Machine fitted with Mitsubishi control. Have sourced another spindle drive but unsure about loading parameters. I will not be able to upload parameters from old drive , as it probably wont power up. According to some documentation I have there should be a backup of the parameters in the control and should be downloaded to the drive on power up.
    Do the parameters load automaticaly or is there a procedure to do this.
    Any help on this would be appreciated


    Jack2012
    Reply With Quote Reply With Quote
  2. 07-25-2012, 06:46 PM #2
    botha.y
    botha.y is offline Registered
    Join Date
    Jan 2011
    Posts
    350
    Is that a 700 control?

    It is possible that the previous user has put the backup on the hard drive. I have the instructions for NC backup as well as PLC backup and restore. For NC restore, I would guess you reverse A and B, not sure though. Gimme your email if you need it.

    Cheers.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Replacing Fanuc AC Spindle Drive
    By barchdesigns in forum Fanuc
    Replies: 7
    Last Post: 04-22-2012, 06:35 PM
  2. Replacing a Floppy drive on Fadal VMC 8030?
    By ColinBC in forum Fadal
    Replies: 6
    Last Post: 01-24-2012, 09:28 PM
  3. 1986 qt10 getting rid of hi/low unit and replacing spindle drive
    By carbidecraters in forum Uncategorised MetalWorking Machines
    Replies: 0
    Last Post: 03-15-2009, 11:10 PM
  4. Tuning Bosch Drive cards when replacing SEM Motor
    By RMARCH in forum Bridgeport / Hardinge Mills
    Replies: 1
    Last Post: 03-03-2006, 06:34 PM
  5. Replacing Floppy Drive on Machine Controls
    By ObrienDave in forum DNC Problems and Solutions
    Replies: 2
    Last Post: 08-01-2005, 02:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules