I am trying to drive one stepper and I connected the circuit and tested it using the Breakout board software, the motor spins perfectly but with Mach3 the axis pul LED in the BB just have a dim light and the motor don't spin >>>>I think it is the output signal from mach so How can I change it?
Help PLEASE
Thread: Mach3 output signal
Results 1 to 3 of 3
Threaded View
-
04-28-2012, 03:09 PM #1
Registered
- Join Date
- Apr 2012
- Posts
- 0
Mach3 output signal
Reply With QuoteSimilar Threads
-
How to send the same output signal for two axis
By panto in forum Mach Software (ArtSoft software)Replies: 1Last Post: 04-29-2011, 10:47 AM -
1.6V-3.0V random signal voltage parallel signal from output – Any advice?
By cjchands in forum Mach Software (ArtSoft software)Replies: 0Last Post: 11-12-2009, 11:36 AM -
Input/output signal on 0M-C
By padobranac in forum FanucReplies: 3Last Post: 10-28-2008, 03:49 PM -
No Output Signal
By tz1238 in forum Machines running Mach SoftwareReplies: 1Last Post: 01-27-2008, 09:57 PM -
Diag: Output Signal: Enable 1 help...
By Flatline's Up! in forum Syil ProductsReplies: 11Last Post: 04-06-2007, 08:11 AM
Tags for this Thread
Posting Permissions
