[jassk]

Hi again,

It looks like I have a really bad product bought because everyday I have a problem with it. From yesturday laser won't move along Y axis. I've tryed to restart the sistem but it's not helping even though that moved a few times and after that the same.

And I've tryed to engrave or cut but still won't move or it'g going up and down on Y axis with a lot of vibration.
So any ideas about this please???

Goran

[Exsecratio]

Driver card or motor for the Y axis is either on it's way out, faulty or has a loose connection.

Swap the wires over with the X axis card and see if the problem travels with it, if so then it's the driver and not the motor.

best wishes

Dave

ps: remember the pad controls will also be swapped if you swap the wires over. ie: X will become Y and Y will become X

[jassk]

Well I already try that and probably the card is dead. Even that the head is trying to move there is problem with the power I guess. However if there is something more that I should know please for info before I start whatever I'll do.

Goran

[G.Weike-Abby]

hi

i think maybe you need to chec the power supply.there is a switch.tomorrow i will send you the pic for your reference.

Abby
[email protected]
[email protected]
Skype:abbylilu
Web:laser engraving machine?laser cutting machine?cutting plotter at G.WeiKe

[G.Weike-Abby]

Hi，

Pls check the pic.It is the correct driver setting.

Abby
G.Weike Laser
[email protected]
[email protected]