I am in the process of putting together a DIY CNC Router. I just purchased 3 used MCG IS34027 NEMA 34 650oz servo motors. Unfortunately, I have not found a wiring diagram for these motors. The motors are I believe 8 wires. I need to purchase drivers and breakout board as well as power supply that will work with these motors. Anybody have any suggestions on what might work with these motors? Sorry for being so ignorant on this, but hopefully, someone on this forum can steer me in the right direction.:drowning:
Results 1 to 2 of 2
-
06-05-2012, 04:15 AM #1
Registered
- Join Date
- Apr 2012
- Posts
- 4
Help with selecting drivers/breakout boards
-
06-05-2012, 01:59 PM #2
Registered
- Join Date
- Jul 2011
- Posts
- 0
It depends on your knowledge and experience.
I would rather buy a kit, motors driver boards and power supply from a vendor which will help you with the set up.
The motor number typed in google comes out on top of the search.
http://www.alstron.com.sg/Motor_MCG/PDF/IS34027.pdf
Reply With QuoteSimilar Threads
-
Open Source Boards Available, Stepper Drivers and Break Out Boards
By pminmo in forum Open Source Controller BoardsReplies: 762Last Post: 06-23-2018, 01:46 AM -
breakout boards
By daniellyall in forum Stepper Motors / DrivesReplies: 1Last Post: 04-14-2012, 01:34 AM -
CNC4PC Breakout Boards
By Degrom in forum CNC Machine Related ElectronicsReplies: 2Last Post: 01-31-2009, 12:52 AM -
Breakout boards
By DaPyro in forum CNC Machine Related ElectronicsReplies: 15Last Post: 06-23-2006, 07:22 PM -
breakout boards
By Gads in forum CNC Machine Related ElectronicsReplies: 2Last Post: 03-06-2006, 12:39 AM
Posting Permissions
