[xray34]

HI guys,

Can anyone tell me what bearings I will need for the 'X Axis' on our Hawk 5M ???

I need to get them before I strip the machine down so as not to lose any production time.

Thanks for any guidance guys. :-)

[bloke]

You can at a pinch use mm9306w12 angular contact bearings (1 pair).
These are a tad thicker than the standards at 15.875mm thick each.

Failing that, get some 47 x 20 x 15 angular contacts. I can't find the exact number as I'm at home at the mo.
I'll have a look tomorrow morn!

[xray34]

You can at a pinch use mm9306w12 angular contact bearings (1 pair).
These are a tad thicker than the standards at 15.875mm thick each.

Failing that, get some 47 x 20 x 15 angular contacts. I can't find the exact number as I'm at home at the mo.
I'll have a look tomorrow morn!

Fabulous.. what more could I ask for.

Thanks so much ''bloke''

I will get onto our buyer in the morning to sorce a set.

Thanks again :-)

[xray34]

You can at a pinch use mm9306w12 angular contact bearings (1 pair).
These are a tad thicker than the standards at 15.875mm thick each.

Failing that, get some 47 x 20 x 15 angular contacts. I can't find the exact number as I'm at home at the mo.
I'll have a look tomorrow morn!

Hi Bloke,

Our buyer says that mm9306w12 doesnt match your suggested 47 x 20 x 15
as it says they are 30mm bore???

Also He asks is could the 47 x 20 x 15
be 47 x 20 x 14 as he cannot source a 15??

Also are they sealed or open??

HELP please

Thanks

Xray34

[xray34]

Anyone else help please?? getting near desprate times. thanks :-)