[godzila]

Dear all,

I'm new member here.
I ussualy using fanuc controller, and I have problem with old machine (no manual book), mitsubishi machining center using meldas 500. But don't know step by step transfer NCdata, or using tape mode. Please help...

Thanks all

[godzila]

dear all

please need the config of PC side, and machine side.
also the RS232 config. Is same config with Fanuc cable RS232 ussualy I use?

Thanks before

[botha.y]

Give me your email and I can send you a document for 500M series.

Cheers.

[gm3211]

The Fanuc cable will work on the Mitsubishi 500 series control. The trick is to set the Device correctly and then the specific Input/Output parameters. The NC running, data in/out should all be the same to eliminate possible issues. There are so many parameters here that can be mis-configured.

Feel free to give me a call or shoot me an email and we can try to work on it together.

[mansour]

dear all
we hvae deep hole drilling from ixion mitsubishi control thier is error ABS 1001 07
i need help

Thanks
mansour

[anthoo_odin]

[Quote = botha.y; 1112756] Dame tu correo electrónico y te puedo enviar un documento de la serie 500M.

¡Salud. [/ Quote]


¿Puede usted al igual que mi pase por favor !!!!!!

[lalocompras]

Hola buenas tardes

me lopodrias enviar a mi tambien porfavor.

[email protected]

[ZOKIPOKI]

do you have expirience with 300 series i wnt to transfer parameters and tool offset
[email protected]