I'm drilling then boring a taper with a Sandvik 880 drill. I have the drill set as tool 9 so the drill cycle calls up T0909. At the end of the cycle I use T0900 to cancel the offset then call up T0919 which has my drill offset touched off like a boring bar. The screen shows that T0919 is active but it moves to position as if the T0909 is still active. I've changed the offset of T0919 from X-14.8977 to X-10 and it went to the same place. Is this a parameter I need to change? I can't find the book and google hasn't helped me yet.