I've just aquired an old D&M 6, 3 axis decktop mill and am looking for a manual or someone with some knowledge of the machine. I came out of a school and looks like it had very little use, mostly making signs in plexiglass. The spindle runs in manual mode however I haven't found out how to move the axis. The old 386SX computer still has the system loaded including what looks like a reasonably capable, for it's time, 2 1/2 axis CAD/programming system called AUTOSKETCH for their somewhat funky programming language. I was told the machine runs however I have to replace the estop switch as it's also a lockout switch with no key, I just bypassed it for now to get it running. I'd appreciate any help I can get as I'd like to see if it will run before I have to strip all the drives and computer and install modern components.