In a trade I got with some machines I aquired a jnc45 Miyano with a fanuc 3t. There is one big problem with it. The shop that it was in went under. During the time it was vacant the shop was broken into by scrapping thieves. They had taken cutters and cut all of the wiring out if the back control box where all of the circut boards were mounted. So the machine has all boards, ps servo drives, etc. All of the ends of each piece of wire cable is still there. Not sure what to do with the machine now. Hate to scrap it as it was a good machine. If I could find one that someone is parting out to where I could by all of the cables would be nice. I uave emailed anyone with a 3t part on eBay and asked about cables but no luck. The thieves got maybe 30 dollars worth of copper. Such a waste. Any advice?