I cut some of this material Friday for a prototype product. It cut fine....where the material was flat...but the material seems to not be perfectly flat like a sheet of acrylic...I am not sure if the sheet was defective or if that is the nature of the beast.

If this is the way I will get material then I think we will need a vacuum table to hold the sheet flat...so my question is what material would work best for the top of the vacuum table so the laser beam does not create problems. I have an 80w CO2 with a 4'x8" bed. I have a vacuum pump and have some experience with vacuum tables I am just not sure what the top material should be...I am open to suggestions.

Tom