586,391 active members*
2,869 visitors online*
Register for free
Login

Thread: Direct Numeric Controller

Results 1 to 5 of 5
  1. 06-11-2012, 10:24 AM #1
    bdrk
    bdrk is offline Registered
    Join Date
    May 2009
    Posts
    14

    Direct Numeric Controller

    Dear All
    We have a problem with Chiron =Fanuc O-MC= controller. Problem is there is no DNC or RMT key on control panel. How can we run the machine via computer.

    P.S: No problem send or receive program from machine to computer or computer to machine because has equipped =Edit= key on panel:drowning::drowning:
    Reply With Quote Reply With Quote
  2. 06-11-2012, 08:22 PM #2
    underthetire
    underthetire is offline Gold Member
    Join Date
    Feb 2009
    Posts
    6028
    Does it have the tape mode?
    Reply With Quote Reply With Quote
  3. 06-12-2012, 01:52 AM #3
    Willydke
    Willydke is offline Registered
    Join Date
    Jan 2007
    Posts
    48
    check in ladeer DGN 127.5 and send me a pichure lader
    Reply With Quote Reply With Quote
  4. 06-12-2012, 07:46 AM #4
    bdrk
    bdrk is offline Registered
    Join Date
    May 2009
    Posts
    14
    Dear underthetire,
    Unfortunately no have "tape mode" just "edit mode"
    Reply With Quote Reply With Quote
  5. 06-12-2012, 01:02 PM #5
    Willydke
    Willydke is offline Registered
    Join Date
    Jan 2007
    Posts
    48
    check or not check the diagnostic 127.5 in lader send me apicture .
    if you do see DGN 127.5 in lader no have mode tape need modified lader
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. direct control / direct phase
    By djwez in forum LinuxCNC (formerly EMC2)
    Replies: 9
    Last Post: 06-04-2017, 11:21 AM
  2. DNC direct numeric control
    By AMTB in forum DNC Problems and Solutions
    Replies: 0
    Last Post: 04-21-2012, 07:12 PM
  3. Controller for Servo Motor - Automation Direct
    By rrossey in forum Controller & Computer Solutions
    Replies: 2
    Last Post: 02-10-2012, 04:20 PM
  4. GN6 Series General Numeric Controller
    By cncnavy in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 0
    Last Post: 01-22-2009, 08:10 PM
  5. port pin setu[p - direct phase controller
    By Andy Sayno in forum Mach Mill
    Replies: 0
    Last Post: 09-01-2007, 04:09 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules