Hello All-
Been doing my best to work my machines problems out but this one kind of has me stumped.
I am radius profiling 2 sides a 2" thick piece in z with multiple passes in x stepping y over in .01 increments to obtain a smooth curve.
The problem i am having is that as the cutter works across y it isnt square to x.
The opposite end is parallel to it but it is out approx. .625 in 14" Granted that only works out to about .0002 per pass(3100 passes)...but i cant for the life of me figure out why its doing it or how to solve it.
I started in cv mode for speed, switched to exact stop mode-no difference
set my speed to half and accel to a crawl- no difference.
I could accept it being lost steps if it didnt do exactly the same thing every time, and it didnt cut a perfect parallelogram.
the code was generated from sketchup through freemill but it is a pretty basic program length aside.
ive cut the piece 3 times and the exact same problem every time.
Any suggestions would be greatly appreciated.
Dave