I was able to install Mach 3 and get it to run after Mach 2 kept rebooting my compaq pentium 4 machine. Now when it loads, it gives me an error of External Estop Requested and I cannot reset it. I went into the setup and saw it in the Input Signals but how do I turn it off? I do not have anything other than the xylotex 3 axis driver board connected to the parallel port and 3 nemo 23 motors. I don't have any safety switches or anything.
And second, if I can get past this, how do I get to the jog screen in Mach 3? I can't remember how I did it when trying Mach 2 on my main machine. All I want to do right now is see the computer and driver board make the motors turn.
Thanks!