Is there a parameter I can change, or something else(setting) for torq cut t3, when cutting arcs the machine hesitates at the , 180 quadrant points..My other one works fine,any ideas??
Results 1 to 1 of 1
-
07-01-2012, 01:35 PM #1
Registered
- Join Date
- Feb 2009
- Posts
- 17
torq cut t 3 with dx32 hesitates when cutting arcs or circle , 180 quadrant points
Reply With QuoteSimilar Threads
-
Torq-Cut 22 DX32 Dripfeed?
By OC_ in forum Bridgeport / Hardinge MillsReplies: 6Last Post: 12-13-2023, 04:28 AM -
dx32 torq cut 22 software
By holmes9921 in forum Bridgeport / Hardinge MillsReplies: 2Last Post: 08-07-2011, 05:16 PM -
points to lines/arcs
By vmax549 in forum AutodeskReplies: 7Last Post: 10-14-2008, 02:05 PM -
Torq Cut 4 with DX32 postprocessor
By emvali in forum Bridgeport / Hardinge MillsReplies: 0Last Post: 08-05-2008, 08:13 PM -
Points on arcs
By gguidi in forum AutodeskReplies: 2Last Post: 07-25-2006, 01:49 PM
Posting Permissions
