Hi friends
I encountered a problem with my control and will appreciate all the help I can get.
The machine is Zayer machining center with Heidenhain TNC 415 control.
When turning on the machine, after a 45 days shutdown period, a message that the backup batteries should be replaced appeared. The message appeared in German and so are all messages from the control since than, though the language before was English.
The batteries where replaced but the machine power will not start-up. The user interface is functional and it is possible to brows between the different screens,
But there is no power to the motors. No error message appears.
Any suggestions how to approach this problem will be greatly appreciated.
Thank in advance