Hello,
I am having some problems with a Gleason 125H Gear Hob. Can any one Advise as to what the following Warning code refers to?
Warning 419: User File Error
Any help would be appreciated
Thanks
Hello,
I am having some problems with a Gleason 125H Gear Hob. Can any one Advise as to what the following Warning code refers to?
Warning 419: User File Error
Any help would be appreciated
Thanks
Have you asked Gleason?
Dick Z
DZASTR
How old is the machine? Gleason doesn't seem to want to service any machine over ten years old. They'd rather sell you a new one.
Dick Z
DZASTR
Ok, Problem solved, or at least pinpointed
After long discussions with the service tech at Gleason, here is what we figured out...
First Off, I have a Gleason Phoenix 125GH Gear Hob with Fanuc 15MA Controller, this is important, as this machine is friggin old
This machine uses a single board computer to communicate between the Gleason computer and the Fanuc controllers
The Warning "419: User File Error" is the controller telling the system that it cannot communicate with the Gleason computer. This was further realized because we could not initialize the Gleason screen. The gleason computer is above the Floppy Drive begind the metal plate.
I was told this happens because of the following reasons...
1) The A: drive (Floppy) is either not functioning or a small 2 Amp fuse in the unit has blown
2) The CMOS battery in the Gleason Computer needs to be replaced
3) There is a loose wire connection somewhere between the computer and the Fanuc Controllers
Hope this helps some one somewhere get started.
Thanks,
Alex C.
Dear Simplyinsane11 I have same alarm on Gleason 125GH Gear Hob, your machine is running now?
Dear Simplyinsane11 I have same alarm on Gleason 125GH Gear Hob, your machine is running now?
1.Check all fuse are ok.
2.No any battery for Gleason computer.
3.No any loose connection found.
So please guide me.
Regards,
Suhas.