Just a quick question. I'm wiring my new keling motors to my g540. The diagram for the motors shows them as A+ and A-, B+ and B- while the driver says A and /A, B and /B. I couldn't find anything online. Just wondering which goes where...
Just a quick question. I'm wiring my new keling motors to my g540. The diagram for the motors shows them as A+ and A-, B+ and B- while the driver says A and /A, B and /B. I couldn't find anything online. Just wondering which goes where...
A+ is the same as A, A- is the same as /A, B+ is B, and B- is /B
Art
AKA Country Bubba (Older Than Dirt)
And, it really doesn't matter how you connect the motor. Connect one of the A wires to one of the A terminal, and the other A wire to the other A terminal. Then do the same with the B wires. If the motor turns the wrong direction, then reverse either the two A wires or the two B wires, or just flip the polarity of the DIR bit in Mach3/EMC.
Regards,
Ray L.
Thanks guys!