Hi guys,
I have managed to get a few delta servo drives and motors but a little overwhelmed by all settings needed to get the drive to work with Mach 3
Drive spec:
asd-a0721-ab
AC servo drive
A series
750w output
220v single phase input
2500ppr encoder resoloution
Supports ECMA series servo motors
I have a PMDX 126 and have worked out I need to output step to CN1 pin 37 (sign) and direction to CN1 pin 43 (Pulse)
I am guessing that i also need to set the perameters to have the drive accept step and direction commands as well as the setting to keep the drive work without burning out.
I will admit that so far I have only used steppers so just need a bit of push in the right direction to get these servos working!