[Rojas]

Excuse me, please help me with trouble on Haas SL-40.

Trouble: Turret not go to home.

Antecedent: The machine was complete off by 4 weeks, becouse the coupling between servo turret and turret was broken.

NOW:We changed the coupling, assembled the servo turret and power ON the machine. When I push POWER UP RESTART the X-Z axis and spindle go well to home but the turret is still.
When I select MDI then push FWD or REV KEY the piston actuate the turret unclamp but not turn.
We check the sensors of clamp and unclamp and is operating well. We checked too the parameters and its according the parameter list. The air input is ok.
Thank you.

[roamer]

I believe you need to adjust the grid offset if you disconnected the servo from the turret shaft.

Sent from my DROID RAZR using Tapatalk 2

[hdcncservices]

first of all, you need to manually to tool one and loose the screw from the couplin motor end, and zero return on c turret on single mode and tight couplin screw, make sure turret clamp & unclamp properly. you all set to go, good luck

[Rojas]

Dear Roamer.

Thank you, with your information today the turret is working fine.

Thank you , thank you.

[Rojas]

Hdcncservices.

Thank you, with your information, the turret is working well.

I´m very grateful.