586,103 active members*
3,309 visitors online*
Register for free
Login

Thread: NCStudio and Z cutting depth

Results 1 to 2 of 2
  1. 08-19-2012, 05:08 PM #1
    Pakmoto
    Pakmoto is offline Registered
    Join Date
    Aug 2012
    Posts
    0

    NCStudio and Z cutting depth

    Firstly I'd like to say Hi as this is my first post!

    I've hit a wall as I can't seem to get NCStudio to cut depth, unless I do it manually in '2D pit depth'

    All looks good when I simulate in Artcam, the cuts are the correct depth,
    But NCStudio ignores Z axis cut depth, so I'm a little lost.

    Regards Pak...
    Reply With Quote Reply With Quote
  2. 08-21-2012, 12:34 PM #2
    Pakmoto
    Pakmoto is offline Registered
    Join Date
    Aug 2012
    Posts
    0
    My Bad!
    Schoolboy error, I had Artcam toolpath output to 2D

    Doh! well all sorted now.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Cutting Rotary Wrapped on Y with NcStudio
    By sparsell in forum Post Processors
    Replies: 0
    Last Post: 07-23-2012, 08:00 PM
  2. Aspire depth Cutting
    By fastpcuser in forum Vectric
    Replies: 3
    Last Post: 04-28-2011, 06:38 AM
  3. Cutting depth issues
    By NylonAdmiral in forum Mastercam
    Replies: 17
    Last Post: 10-14-2009, 04:07 AM
  4. Setting cutting depth
    By awemawson in forum FeatureCAM CAD/CAM
    Replies: 2
    Last Post: 10-30-2005, 10:05 AM
  5. Possible to have more than 1 Cutting depth?
    By CJL5585 in forum SheetCam
    Replies: 4
    Last Post: 06-02-2005, 10:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules