This RFQ has been fulfilled. Thank you all for your time and consideration. -Luke
Hey guys,
I'm looking to find someone to produce these. Here's a quick photo.
Holes on side are #10-32 through tap (colinear)
Hole (not visible) on top is 1/8" at 10* from surface plane normal
Material is currently specced at 1/4" thick but may end up +/- 1/16"
Width of item is ~2.5"
Please PM me and I will send off the CAD file for evaluation and quoting.
6061 was specced but this is mostly an aesthetic piece so I am open to your suggestions for material
Was hoping for a natural satin finish OR a satin black finish.
I look forward to working with you