hi folks, do any of you use the "DXF File Importer" function on the haas lathe.
I have just taken purchase of a haas tl1 and am working my way through the functions. However so far i have been unable to run any programmes from this function.
I am creating the .dxf file in onecnc xr3 mill, loading into the lathe following the instructions (ips walk through for lathes and on screen also) but no matter how simple the profile when i go to run it, it throws up a warning and wont do anything.
When i look up
DXF Import | Haas
it shows a walk through for mil but the lathe section is locked ?
Any ideas would be brilliant
Thanks
Paul h