[camtd]

I am using a product called VEGACNC, DNC Systems, Backplotters, NC Editors, Feedrate Optimization to verify my .nc
code against.

When I export a .stl out of Edgecam 2012R1 the .stl exports at the original C.S. not at the programmed C.S. I do not have a way to move the .stl
file in my NC Verifier

Is there a setting or way to export a .stl file for a chosen C.S.?

Thank You

[meegers]

Hi camtd,

As far as I can see (unless anyone else knows better) Edgecam will export the STL relative to the TOP cpl.

The easiest way to get round this is get into the routine of using TOP cpl as your initial cpl.