586,315 active members*
3,270 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Hyundai Kia > SKT 21 Tailstock question with fanuc oi-TC

Thread: SKT 21 Tailstock question with fanuc oi-TC

Results 1 to 2 of 2
  1. 09-07-2012, 06:58 PM #1
    340
    340 is offline Registered
    Join Date
    Feb 2007
    Posts
    6

    SKT 21 Tailstock question with fanuc oi-TC

    Hello,
    Can anyone advise how to use the tailstock on an SKT-21 turning center,
    M25 advances towards the chuck and M28 fully retracts, but I can't figure out how to position it at a given location, the manuals don't have much to say on the subject, any help is greatly appreciated.

    Thanks
    Reply With Quote Reply With Quote
  2. 09-13-2012, 09:30 PM #2
    abmts
    abmts is offline Registered
    Join Date
    Feb 2010
    Posts
    10

    KIA Tailstock

    Hi there

    The tailstock will automatically stop when it touches the work piece clamp and apply the set pressure all in one movement.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Another Tailstock Question
    By rickmantoo in forum Shopmaster/Shoptask
    Replies: 5
    Last Post: 06-21-2012, 07:54 PM
  2. TL-1 Turret/tailstock question
    By hercules in forum Haas Lathes
    Replies: 9
    Last Post: 02-13-2009, 09:33 PM
  3. Tailstock Alignment Question
    By tigermothracing in forum MetalWork Discussion
    Replies: 1
    Last Post: 09-05-2008, 03:49 AM
  4. Haas SL-30 Tailstock question
    By chrisryn in forum Haas Mills
    Replies: 1
    Last Post: 05-07-2008, 07:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules