Hi everyone, I am super new to using forums and even more of a noob at using the Tormach 770 pcnc purchased by my university. I have been tasked to get this machine up and running but being unfamiliar the device, I am not even sure where to start on purchasing drill bits for the machine. I was hoping to get some advice on some initial purchases focusing primarily on the type of collets or drill bits I may need. This machine will be used for reductive prototyping for a senior design class, mostly dealing in plastics, delrin, acrylic, uhmwp, etc. Can anyone suggest some basic drill bits and where I could purchase them from just as a start-up? Any advice would be helpful.