[thomasz]

Hi,

I have to change the cylinders from the hi/lo-sytem (4020HT).
Thats no problem - but in the manual are two points I don't understand:

The reservoir is full when oil enters the 5/32 line on the actuator.

Which line is exactly meant? There are several 5/32 lines on top of the
Head – and all are connected together in some ways.


WARNING DO NOT allow an excessive amount of oil to flow into the separator.

What is the separator?

Bye,
Thomas

[hydes]

If i remember rightly
There are 3 pipes on each block
Air in (from the y connector)
Interlock
Air out (to the piston)

Remove the in and out pipes and fill till it comes out the other hole(remember where they go though)

[thomasz]

Thanks - it works.