It does not finish the last pass at final depth. It stops about an inch or so from completing then either goes to the next flat or stops if it is the end. It does not finish either at the level of the pockets nor at the bottom of the part.
Attached is the .xfa file zipped.
Any suggestions? Thanks for all the help a couple of threads ago to get me to this point.
Thomas
Results 1 to 14 of 14
Threaded View
-
01-09-2006, 03:19 PM #1
Registered
- Join Date
- Sep 2003
- Posts
- 69
Z level finishing does not finish final depth pass
Reply With Quote
Posting Permissions
