[cobii]

Hi guyz

I am new to this forum, and I am very new to hypermill and using hypermill 2010 sp1.

I am trying to do turbine blade machining Near Root and Shroud areas using
5X BLADE POINT MILLING / SWARF CUTTING am always getting "warning :stop Due to collision tool holder" even whatever (lead tilt and tilt angle) please help how to overcome this problem

Thanks

[muhammet-tas]

Hi guyz

I am new to this forum, and I am very new to hypermill and using hypermill 2010 sp1.

I am trying to do turbine blade machining Near Root and Shroud areas using
5X BLADE POINT MILLING / SWARF CUTTING am always getting "warning :stop Due to collision tool holder" even whatever (lead tilt and tilt angle) please help how to overcome this problem

Thanks

You need changed ur tilt angle and ur tools check up seting u can useing automatic selection or manuel?
add paramaters photo we can see it in here tnx.

[Alan L]

I would suggest communicating with the OPEN MIND Help Desk - [email protected]. There is a team of professionals there to help answer your questions.