[elafing1]

Is it possible to specify a length before placing line at a angle from another entity.

[moldcore]

What version are you using? There has been a Add-In available for some time but I’m not sure how far back. If it's available in your version try: Add-Ins > CDE Open > Tools.cde. > Open > 2DTools.

[elafing1]

Thank you Moldcore, I did find that add in. f.y.i. 9.0.3.. It will halp me in some future designs however I will paint a picture. I have 5 lines running from vertical to 20 deg. not equal deg spacings. Now I need to create a line 75deg from top point on each line at 2.5 inches long. Typically I select create line at angle type 75 as deg. then select vertical line then right click line and enter length. Sometimes I will have up to 40 vertical lines at varying degs, so with a line at top and one at bottom that is 80 lines that I must right click and enter a length for.. quite time consuming and P.I.A ,, Any ideas,

[moldcore]

Sounds like fun! Not really. With KeyCreator there are number of solutions but I’m afraid none are going to be any faster. One comes to mind. Have you tried creating a line 2.5 inches long that you can use to the copy/paste or Xform old/new/copy then rotate to the angle you need.

Even though I’ve been a user for over 20 years, I’m not a full time user so I’m sure there are better solutions out there. The Webforum on Kubotek’s website is a great source for solutions to problems like this.