[Bakes144]

I have a Denford Senior 200 on Fanuc OT and when I send it 'Home' the axis give an over travel alarm. I have tried the P Can button trick on start up which dissables the near limit switches and allows the machine to hit the dead stop switches. This worked with the X axis and now reads X0.000 but the z axis still gives me the alarm... I have had the machine for a month & still have not cut any metal! Just managed to solve a 401 alarm & now this!

Thanks,

Paul

[newlife]

Have you checked the limit switch wiring and switch action? We've dealt with that with other lathes with thae OT.

[newlife]

Have you checked the limit switch wiring and switch action? We've dealt with that with other lathes with the OT.

[Bakes144]

Thanks for your help, it turns out that the limit switch stop plate was put on upside down! Finally cutting metal!

Thanks!