[riphet]

Hello,

Building machine with 3 axis, the Y axis need two twin motors.
Then need equal signal by each motor.

Ports and Pins, Motor Outputs:

I try write double Pin# writing with sintax:
Y axis Step Pin#: 8,5
Y axis Dir Pin#: 3,4

but the signal cable only activity on 8 and 3.

So, how to setting double Pin# by Axis ???

[ger21]

Set up one motor as the Y axis, and one motor as the A axis, and slave the A axis to the Y axis using Config >Slaving

[neilw20]

Those commas, went out when command lines evaporated.
We assume you are talking about Mach3.